In today's dynamic technological environment, automation and electronic products must change rapidly to provide versatility while supporting increasingly intelligent and networked mechanical systems. With this in mind, IDEC creates products to meet these needs. IDEC designs and manufactures control automation products that are sold to original equipment manufacturers.
WMB marking card - as card - Marked - F21, ..., F30 (10x) - stretchable 5 - 5.2 mm - Vertical marking - snap-on t ...
End and intermediate plate - 0.8 mm thick - for 3-conductor terminal blocks - orange
1-conductor female connector - CAGE CLAMP® - 2.5 mm² - Pin spacing 5.08 mm - 10-pole - clamping collar - 2,50 mm² ...
1-conductor female connector - CAGE CLAMP® - 1.5 mm² - Pin spacing 3.5 mm - 20-pole - 100% protected against mism ...
TOPJOB®S triple-deck terminal block - through/through/through (L/L/N) - with marker carrier - rail mount - 2-cond ...
Ground busbar terminal block - for (10 x 3) mm busbars - 3-pole - CAGE CLAMP® - 16,00 mm² - green-yellow
Disconnect terminal block - knife disconnect - with additional jumper location - rail mount - 2-conductor - 5.2 m ...
PCB terminal block - push-button - 1.5 mm² - Pin spacing 3.5 mm - 4-pole - Push-in CAGE CLAMP® - 1,50 mm² - gray
End and intermediate plate - 4 mm thick - gray
WMB marking card - as card - Marked - 21 ... 30 (10x) - not stretchable - Horizontal marking - snap-on type - whi ...