In today's dynamic technological environment, automation and electronic products must change rapidly to provide versatility while supporting increasingly intelligent and networked mechanical systems. With this in mind, IDEC creates products to meet these needs. IDEC designs and manufactures control automation products that are sold to original equipment manufacturers.
PCB terminal block - lever - 4 mm² - Pin spacing 5 mm - 2-pole - Push-in CAGE CLAMP® - 4,00 mm² - gray
End and intermediate plate - 2.5 mm thick - orange
WMB marking card - as card - Marked - 1 ... 50 (2x) - not stretchable - Vertical marking - snap-on type - white
4-conductor center terminal block - without push-buttons - 1-pole - 2.5 mm² - CAGE CLAMP® - 2,50 mm² - orange
Staggered jumper - from 1 to 5 - insulated - gray
Triple-deck terminal block - Shield/through/through terminal block - 2.5 mm² - with marker carrier - for DIN-rail ...
Optocoupler module - Nominal input voltage: 24 VDC - Output voltage range: 20 € 60 VDC - Limiting continuous curr ...
Busbar - tin-plated - 1000 mm long - Cu 10 mm x 3 mm
WSB marking card - as card - Marked - 21 ... 30 (10x) - not stretchable - Vertical marking - snap-on type - white
Carrier terminal block - rail mount - 2-conductor - 7.5 mm - gray